Corporate Logo Screen Saver Version 4.0
 
    Screen Saver for Windows 3.1, Windows NT and Windows 95

New for this release:
	New version for Windows 95 and Windows NT 3.5.1 and above                

Installation

	CHANGE THE CURRENT DIRECTORY TO THE DIRECTORY THAT CONTAINS
	THE SETUP PROGRAMS AND THE COMPRESSED FIELS ( *.??_ ).
	Run "SETUP.EXE" to install Corporate Logo Screen Saver
	Run "SETUP32.EXE" to install 32 bit Corporate Logo Screen Saver
	for Windows NT and Windows 95

Multiple PC Installation

The file SSCORP.INI is created during installation.  This file may also be
copied to simplify installation for the 16 bit version


DISCLAIMER:  Use Corporate Logo Screen Saver at your own risk.  The author 
does not warrant the suitability of Corporate Logo Screen Saver for any 
specific purpose, and assumes no responsibility for damages of any kind 
resulting from its use.  Use of these programs for any period of time 
constitutes your assumed acceptance of this agreement.

		W A R N I N G 

	If you use the password protection option, you MUST remember your 
password!  Corporate Logo Screen Saver will appear after the time you 
specified in the Control Panel desktop function.  If you forget your 
password you will have to boot your computer to regain control.  All work 
not saved before rebooting will be lost.    
	This screen saver has an administrative password option.  When this 
option is in effect,  this screen saver can be stopped by administration 
or management.   WINDOWS NT AND WINDOWS 95 SAVER PASSWORDS ARE HANDLED BY 
THE OPERATING SYSTEM, NOT THIS SCREEN SAVER.


==========================================================================

			Administrative Password
			  (Windows 3.1 only)

By default there is no administrative password.  A procedure to add an 
administrative password follows:

1.  Start Corporate Logo Screen Saver (SSCORP) in configuration mode.  Set
    the password to your administrative password.

2.  View file CONTROL.INI, section [ScreenSaver], profile name
    of Password.  Write down your encrypted password.

3.  Reconfigure SSCORP and remove the administrative password.

4.  Insert the administrative password into SSCORP.SCR using either 
    Method A or Method B. (below)

Method A:

    Use a Windows resource editor, such as Borland's Resource Workshop, to 
    change string resource 514 to your encrypted password, in SSCORP.SCR. 

Method B:

    Use Debug or a binary editor.  Find the string "SRCHSTRING".  The 
    periods ( 0x2e ) should be replaced with your encrypted password.  
    Start with the first period.  Remember to end your string with a 0x00
    for ASCIIZ string.
	
--------------------------------------------------------------------------        

	The administrative password is not intended to be easily installed, 
 but for a corporate PC administrator it should present no problems.  An 
 administrative password is not needed for a single user system.  
 Suggestions for other secure and effective methods for installing the 
 administrative password are welcome.
	
	THE ADMINISTRATIVE PASSWORD IS FOR WINDOWS 3.1 ONLY.  WINDOWS NT
SCREEN SAVER PASSWORDS ARE BUILT INTO NT.